User Manual Q&AAnswer
Jan 06, 2025 - 08:51 PM
To connect your Kanto YU2MW speakers to your computer, you can use the 3.5mm stereo mini-jack AUX cable that is included with the speakers. Here are the step-by-step instructions:
1. Make sure your computer is turned off.
2. Locate the 3.5mm audio output jack on your computer. This is usually a green-colored jack and is commonly found on the back or front of the computer.
3. Connect one end of the 3.5mm AUX cable to the 3.5mm audio output jack on your computer.
4. Locate the 3.5mm AUX input on the back of the YU2MW active speaker. This is the speaker with the volume/input select xxxx .
5. Connect the other end of the 3.5mm AUX cable to the 3.5mm AUX input on the YU2MW active speaker.
6. Turn on your computer and the YU2MW speakers.
7. Press the volume/input select xxxx on the YU2MW active speaker to select the AUX input.
8. Adjust the volume using the volume/input select xxxx or the volume controls on your computer.
Once the speakers are connected and the correct input is selected, you should be able to hear audio from your computer through the YU2MW speakers. If you encounter any issues, refer to the troubleshooting section in the instruction manual or contact Kanto support for further assistance.
Add New Comment