User Manual Q&AAnswer
Jan 06, 2025 - 03:28 AM
To pair/sync the transmitter and collar receiver of the Educator EZ-900 Remote Waterproof Dog Trainer, follow these steps:
1. Turn on the transmitter by pressing the lower right button for 1 second.
2. Rotate the intensity dial on the transmitter to "0".
3. Turn off the collar receiver.
4. Place the red dot on the transmitter against the red dot on the collar receiver for more than 5 seconds until the solid green light on the collar receiver starts blinking on and off rapidly.
5. Press the ON/OFF button on the transmitter and then press the S3 button (Front Top) simultaneously.
6. Listen for a confirmation sound from the collar receiver.
7. Test the collar receiver to make sure it has accepted the new transmitter code.
Note: If you have a two-dog system (EZ-902), you will need to follow separate pairing/syncing steps for each dog. For Dog 1, follow the steps above using the S3 button. For Dog 2, follow the steps above using the S4 button.
For more detailed information, refer to the "Pairing/Syncing" section in the Educator EZ-900/902 Owner's Manual.
Add New Comment