User Manual Q&AAnswer
Jan 06, 2025 - 12:34 AM
To install the Rockford Fosgate T1675-S 6.75 Series Component Speaker System, follow these steps:
1. Before beginning the installation, disconnect the negative lead from the battery to prevent damage to the unit and ensure safety.
2. Determine where you want to mount the speakers. Ensure that the mounting location is large enough and deep enough for the speakers to fit properly. If mounting in a door, operate all functions (windows, locks, etc.) to ensure there are no obstructions.
3. Refer to the specification chart in the manual to determine the proper diameter hole to cut for your speaker model. Cutting and mounting templates can be found at rockfordfosgate.com.
4. Mark the locations for the mounting screws and drill the holes using a 1/8" bit.
5. Feed the speaker wires through the cutout and connect them to the speaker terminals, observing proper polarity. The positive terminal is indicated with a "+".
6. Fit the trim ring over the speaker and mount it into place using four screws. Tighten the screws until the speaker is snug to prevent rattling, but do not over tighten.
7. For the tweeter, determine the mounting location and ensure it is deep enough for the speaker to fit. Mark the location for the mounting hole and drill it using a standard 1.75 inch (45mm) hole saw.
8. Secure the inner cup of the tweeter from the front of the door panel to the outer cup from the back of the door panel using a single center xxxx . Tighten the xxxx until balanced pressure is applied to both faces of the mounting surface.
9. Feed the speaker wires through the cutout and connect them to the speaker terminals, observing proper polarity. The speaker's lead wires are indicated with a red wire "+" and a black wire "-".
10. Snap the tweeter into place and secure it with a snap-on trim ring. The protective grille on the tweeter is non-removable and an integral part of the design.
11. Once the speakers are installed, you can proceed with the wiring. Use the provided illustrations in the manual for proper connection and be sure to maintain speaker polarity.
12. If using a crossover, follow the instructions provided to connect the speakers and set any switches or adjustments as needed.
13. Finally, refer to the manual for any additional setup or adjustment instructions specific to your system.
Please note that these are general installation instructions, and it is always recommended to consult the manual for your specific product model for detailed and accurate instructions.
Add New Comment