User Manual Q&AAnswer
Jan 05, 2025 - 09:50 PM
To install the Rockford Fosgate T16 2-Way Full-Range Speaker, please follow these step-by-step instructions:
1. Before beginning the installation, disconnect the negative lead from the battery to prevent any damage to the unit, fire, or possible injury.
2. Determine where you want to mount the speakers. Ensure that the mounting location is large enough for the speaker to mount evenly and deep enough for the speaker to fit without any obstructions.
3. Refer to the specification chart in the manual to determine the proper diameter hole to cut for your speaker model. Cutting and mounting templates can be found on the Rockford Fosgate website.
4. Mark the locations for the mounting screws and drill the holes using a 1/8" bit.
5. Feed the speaker wires through the cutout and connect them to the speaker terminals. Make sure to observe proper polarity when connecting the wires. The positive terminal is indicated with a "+" symbol.
6. If your model has slotted holes, fit the speaker into the cutout and install the screws in the slots at the top and bottom. This will allow you to rotate the speaker to match the remaining mounting holes. Once aligned, tighten the screws.
7. If your model has a trim ring, fit the trim ring over the speaker and mount it into place using four screws.
8. Tighten the screws until the speaker is snug in place to prevent any rattling. Do not over tighten the screws.
It is recommended to have your new Rockford Fosgate product installed by an Authorized Rockford Fosgate Dealer for maximum performance. If you need further assistance or have any other questions, you can contact Rockford Fosgate directly at the provided phone number or visit their website for more information.
Add New Comment