User Manual Q&AAnswer
Jan 04, 2025 - 06:09 AM
To connect your Sound Storm Laboratories SX210 2-Way Car Electronic Subwoofer Control to your car audio system, follow these steps:
1. Choose a suitable mounting location for the unit that will not interfere with the driver's ability to control the vehicle.
2. Use the provided installation parts and hardware to ensure proper installation. Using other parts may cause malfunction or damage to the crossover.
3. Avoid installing the unit in locations with high temperatures, direct sunlight, hot air sources, dust, dirt, moisture, or excessive vibration.
4. Make the following electrical and audio connections using the xxxx terminals provided:
- +12V: Use a minimum 16GA wire and connect it directly to the vehicle's (+) battery terminal, with an inline 3A fuse within 18 inches of the battery.
- GND (Ground): Use a minimum 16GA wire and connect it to a clean, solid chassis ground point as close to the crossover as possible.
- REM (Remote): Use a minimum 16GA wire and connect it to the Remote Turn-On lead of your head unit.
- Audio Cables: Use high-quality RCA cables to make the necessary audio connections as shown in the diagram provided in the manual.
5. Before powering up your system, recheck all connections and set all level controls to the minimum positions. Also, set all crossover controls and switches to the desired positions.
6. Power up your system and set the volume control on your head unit to a moderate level. You may need to further fine-tune the system to suit your taste.
For more detailed information on the controls and features of the Sound Storm Laboratories SX210 2-Way Car Electronic Subwoofer Control, refer to the user manual provided.
Add New Comment