Answer
Jan 04, 2025 - 05:45 AM
To install Hifonics ZS4CX Zeus Coaxial Car Speakers, follow these steps:
1. Confirm Fit: Make sure you have purchased the correct size speakers for your vehicle. If you're unsure, it's recommended to consult a professional installer.
2. Factory Speaker Removal: Most factory speakers are located behind interior panels. You may need to remove the door panel or a small panel around the speaker itself. Refer to your vehicle's manual or consult a professional for guidance.
3. Fit and Wiring: Once the factory speakers are removed, check the fit of the new speakers and ensure there is enough depth clearance. You can test this by rolling the window down and back up while holding the speaker in place. If necessary, use factory harness boots and grommets to run the speaker wires.
4. Coax Installation: Depending on the factory location, follow these steps:
- Factory location behind door panel: Connect the positive and negative wires to the proper terminals on the new speaker. Securely xxxx the speaker into place and replace the door panel.
- Factory location behind small panel: Connect the positive and negative wires to the proper terminals on the new speaker. Securely xxxx the speaker into place and replace the speaker cover panel.
- Custom location: If your vehicle doesn't have a designated speaker location, professional installation is recommended.
5. Rear Factory Locations: Mount the speakers in the same way the factory speakers were mounted. Attach the positive and negative wires to the proper terminals and ensure all wires are secured properly.
For more detailed information and diagrams, refer to the Hifonics ZS4CX Zeus Coaxial Car Speakers Instruction Guide provided in the link.
Add New Comment