User Manual Q&AAnswer
Jan 04, 2025 - 03:24 AM
To install Powerbass XL-62M Marine Grade Speakers with RGB Lights, follow these step-by-step instructions:
1. Turn off the audio system and disconnect the negative lead from the battery for safety.
2. Choose a flat mounting surface that has sufficient depth and air space behind it to accept the speaker. Ensure that the stainless steel mounting screws will not puncture the fuel tank, wiring, or interfere with any moving parts underneath the mounting surface.
3. Use the supplied mounting template to mark the hole for the speaker. Cut the appropriate diameter hole using a hole saw or jigsaw.
4. Place the speaker in the hole (or use the mounting template) and mark the xxxx hole locations using a sharp pointed tool.
5. Remove the speaker and drill a pilot hole in each of the xxxx locations. Use a hand-driven countersink tool on each hole to further inhibit gel-coat cracking of the fiberglass panels.
6. Connect the speaker wire supplied (White + / White w/ Black -) to your radio or amplifier speaker output.
7. Place the speaker into the opening and xxxx in the #8 x 1-3/8-inch (35mm) mounting screws by hand carefully and evenly. Do not over tighten as you fasten the speaker to the boat.
8. Once the mounting holes have been cut, run the speaker wire from the speaker mounting locations back to the radio or amplifier. Use marine-grade grommets to properly insulate any rough edges from the wire insulation when running wires through bulkheads.
9. Connect the gold plated female quick disconnect on the end of the supplied speaker wire to the corresponding color of wire on the gold plated male connector attached to the speaker frame. Connect the other end of the speaker wire to the radio or amplifier according to its owner's manual.
10. After connecting the speakers to the sound system, carry out a listening test at a low volume setting to ensure everything is operating properly.
For RGB LED controller installation and operation, refer to the manual for detailed instructions.
Please note that these instructions are a general guide, and it is recommended to consult with an Authorized PowerBass Xtreme Dealer or professional installer for specific installation advice and to ensure optimal performance and longevity of the speakers.
Add New Comment