User Manual Q&AAnswer
Jan 02, 2025 - 10:53 PM
To connect your sound sources to the Galaxy JIBPA50 Audio Compact Power Amplifier, you have two options.
Option A: If you are connecting the sound sources directly to the projector, follow the suggested wiring diagram (Figure 1) in the user guide. Use standard RCA connectors and/or 1/8" (3.5mm) mini-cables to connect the input devices (e.g., the projector, other audio sources) to the power amp. Match the wiring polarity (red for positive, black or white for negative) and make sure no wire strand bridges the adjacent terminals. Insert all four wires on each speaker into the blue 4-pin captive xxxx plug supplied with the power amp and tighten the locking screws. Finally, attach the power amp plug to the amplifier.
Option B: If you are connecting the sound sources directly to the JIB/PA50 Power Amp and using the external volume control, follow the suggested wiring diagram (Figure 2) and 10k Pot Volume Wiring Diagram (Figure 3) in the user guide. Use standard RCA connectors and/or 1/8" (3.5mm) mini-cables to connect the input devices to the power amp. Strip off the insulation from the external volume control wire and connect it according to the 10k Pot Volume Wiring Diagram. Insert all three pins from the external volume control into the green 3-pin captive xxxx plug supplied with the amp and tighten the locking screws. Finally, insert the captive xxxx plug into the receptacle on the amp’s rear panel.
Please refer to the user guide for detailed diagrams and instructions on how to connect your sound sources to the Galaxy JIBPA50 Audio Compact Power Amplifier.
Add New Comment