User Manual Q&AAnswer
Jan 02, 2025 - 10:11 PM
To wire the Kuryakyn 2719 MTX Road Thunder Sound Bar Plus to your bike, follow these steps:
1. Connect the red wire (hot) directly to the positive terminal of your bike's battery.
2. Connect the black wire (ground) directly to the vehicle's chassis, where paint has been removed, or to the negative terminal of the battery.
3. Use the included T-Tap Quick Connect Female connector to tap into the ACC/Key ignition wire on your motorcycle. Use a pair of pliers to install the connector.
4. Connect the Quick Connect Male connector, located on the orange wire, to the T-Tap Quick Connect Female connector.
5. The blue wire is an optional output that can be used to turn on additional amplifiers if needed.
Please note that it is important to ensure the red power wire is fused at the point where it is connected to the vehicle's battery to prevent damage in case of a short circuit.
For more detailed instructions and illustrations, please refer to the "Installation Instruction" section of the Kuryakyn 2719 MTX Road Thunder Sound Bar Plus manual.
Add New Comment