User Manual Q&AAnswer
Jan 01, 2025 - 10:44 PM
To connect the Q Acoustics QA3010 Compact Bookshelf Speakers to your amplifier or receiver, follow these steps:
1. Make sure that all active units in your system are switched off at the mains before making any connections.
2. Use a good quality stereo RCA phono cable to connect the SUBWOOFER OUTPUT on your amplifier or receiver to the L/Mono Line input on the subwoofer. Push the plugs firmly into the respective sockets to ensure a good contact.
3. Set the controls on the subwoofer to the default settings: Level at approximately half, Crossover fully clockwise (AV setting), Phase invert at 0°, and Auto on set to AUTO or ON.
4. Plug the supplied power cord into the subwoofer and then into an AC supply socket. Switch on the power at the supply socket and then switch the power switch on the subwoofer to 'ON'. The POWER light on the subwoofer amplifier panel will glow, indicating that the subwoofer is operational.
5. Check the settings on your amplifier or receiver to ensure that the subwoofer is set to 'ON' or 'YES'. The subwoofer level on the amplifier or receiver should be set at its default position or 0dB. Set the speaker sizes and positions for all the other speakers in your system.
6. Play some stereo music that you are familiar with and experiment with the Phase invert setting and level control on the subwoofer until you hear a seamless blend between the front speakers and the subwoofer. If the subwoofer stands out too much, it is too loud.
Note: Always follow the instructions in your amplifier or receiver manual for proper setup and configuration.
For more detailed information and troubleshooting, refer to the Q Acoustics QA3010 Compact Bookshelf Speakers User Manual.
Add New Comment