How do I install the CERWIN Vega XED525C 2-Way Component Speakers in my car? (Cerwin Vega XED525C 2-Way Component Speakers Car Accessories Operational Guide)

Answer

manuals.plus

Jan 01, 2025 - 09:31 PM

To install the CERWIN Vega XED525C 2-Way Component Speakers in your car, follow these steps:

1. Tweeter Installation:
- Determine the desired location for the tweeters and ensure it can accommodate the required hole sizes and depth.
- You can flush mount the tweeters by cutting a 1.75-inch (45mm) round opening and mounting the flush mount bezel.
- Alternatively, you can surface mount the tweeters on the dash, door, or rear deck using the provided surface cup and screws.
- Route the speaker wires through the tweeter cup, connect the tweeter to the wires, and snap the tweeter into the cup.

2. Crossover Installation:
- Install the passive crossovers in a well-ventilated area, preferably behind the door panel instead of inside the door itself.
- Connect the input side labeled "AMP" of each passive crossover to the amplifier's speaker output terminals, observing correct polarity.
- Connect the middle terminals labeled "MID" to the midrange speaker, ensuring secure and protected wiring.
- Finally, connect the end terminals labeled "TWT" to the tweeter, again observing correct polarity.

3. Speaker Installation:
- Choose the location for mounting the speakers, such as the rear deck.
- For top mounting, drop the speakers in through the deck, and for bottom mounting, secure the speakers from underneath.
- Ensure a good seal around the frame of the speakers to prevent air leaks.
- Mount the speakers to a flat surface known as a baffle to isolate the front sound waves from the rear sound waves.

For more detailed instructions and illustrations, please refer to the complete operational guide provided with the CERWIN Vega XED525C 2-Way Component Speakers.