User Manual Q&AAnswer
Jan 01, 2025 - 09:28 PM
The installation process for the CERWIN Vega XED650C component speakers is explained in detail in the instruction manual. Here is a step-by-step guide:
1. Tweeter Installation: Determine the desired location for the tweeters, whether it's flush mounting or surface mounting. Make sure the location can accommodate the required hole sizes and depth. The manual provides illustrations for both types of installation. If flush mounting, cut a 1.75-inch (45mm) round opening and mount the tweeter using the provided hardware. If surface mounting, use the provided screws to secure the tweeter cup at the desired angle. Route the speaker wires through the tweeter cup, connect the tweeter to the wires, and snap the tweeter into the cup.
2. Crossover Installation: Install the passive crossovers in a well-ventilated area, preferably behind the door panel instead of inside the door itself to avoid water damage. Connect the input side labeled "AMP" of each passive crossover to the amplifier's speaker output terminals, ensuring correct polarity. Connect the middle terminals labeled "MID" to the midrange speaker and the end terminals labeled "TWT" to the tweeter, again observing correct polarity.
3. Speaker Installation: Choose the location for installing the speakers. The manual suggests rear deck mounting as one option. For rear deck mounting, there are two methods: top mounting and bottom mounting. Both methods require a good seal around the speaker frame for optimal performance. Follow the instructions provided in the manual for the specific mounting method you choose.
It is important to thoroughly read the entire instruction manual before starting the installation process to ensure proper installation and optimal sound quality. If you have any further questions or need additional assistance, you can contact your local authorized Cerwin Vega Mobile dealer or the Cerwin Vega Mobile Technical Support Department.
Add New Comment