User Manual Q&AAnswer
Jan 01, 2025 - 04:23 AM
To connect the Cerwin-Vega SL10SNA subwoofer to your audio system, follow these steps:
1. Determine the type of speaker wire connection you will be using. The most common connection is using bare wire. Strip 1/2" to 5/8" of insulation from the ends of the speaker cable to expose the bare wire and twist the bare wires tightly.
2. Unscrew the binding-post cover on the back of the subwoofer to expose a hole in the metal post. Insert the bare wire or pin connector into the hole, making sure to connect the positive terminal on the speaker to the positive terminal on the amplifier, and the negative terminal on the speaker to the negative terminal on the amplifier. For split spade lug connections, place the "U" shape against the metal post. For banana plugs, remove the plastic cover and insert into the top of the posts.
3. xxxx the binding-post cover back on to securely hold the connection in place.
Note: It is important to observe correct polarity when connecting the speaker wires to ensure proper sound balance and bass response.
Once the subwoofer is connected to your audio system, you can adjust the volume and low-pass frequency settings on the subwoofer to achieve the desired sound. Refer to the manual for more information on adjusting these settings.
Please refer to page 5 of the operational manual for visual illustrations of the speaker wire connections and page 8 for information on adjusting the subwoofer settings.
Add New Comment