How do I mount the Polk Audio DB692 marine speakers? (Polk Audio DB692 Three-Way Coaxial Speakers User Manual)

Answer

manuals.plus

Jan 01, 2025 - 01:35 AM

The Polk Audio DB692 marine speakers can be mounted using either the flush mount or surface mount method. Here are the instructions for each method:

Flush Mount Tweeter Mounting:
1. Mark the center of the mounting spot and cut a 2" (50.8mm) diameter hole using a hole saw, drill bit, or razor knife.
2. Assemble the flush mount cup, clamp, and machine xxxx loosely.
3. Route the wires through the round opening in the bottom of the cup.
4. Press the assembly into the 2" (50.8mm) diameter hole until the clamp edge is below the mounting surface, then tighten the xxxx . The legs of the clamp can be bent outward if needed.
5. Connect the wires from the tweeter terminals of the crossover to the tweeter itself using the faston connectors. Connect the red wire from the (+) terminal of the crossover tweeter output to the red (+) wire from the tweeter.
6. Mount the tweeter by snapping it into the mounting cup.

Surface Mount Tweeter Mounting:
1. Use the base of the surface mount cup as a template and mark the xxxx hole locations. Drill the holes using a 1/8" (3mm) drill bit. Drill a second hole for the speaker wire using a 3/16" (5mm) drill bit.
2. xxxx the surface mount cup to the panel.
3. Push the tweeter wires through the open area at the bottom of the cup and through the 3/16" (5mm) hole in the panel.
4. Connect the wires from the tweeter terminals of the crossover to the tweeter wires using faston connectors. Make sure to connect the red wire strand from the tweeter to the (+) terminal of the crossover tweeter output.
5. Mount the tweeter by snapping it into the mounting cup.

Please refer to the "MOUNTING DIAGRAMS" section in the Polk Audio DB692 Three-Way Coaxial Speakers User Manual for visual illustrations of the mounting process.