User Manual Q&AAnswer
Dec 31, 2024 - 11:49 PM
To install the Polk Audio MM652 marine speakers in your boat, you have two mounting options: flush mount and surface mount.
For flush mount installation, follow these steps:
1. Check for proper clearance and mark the center of the spot where you want to install the speaker.
2. Cut a 2" diameter hole using a hole saw, drill bit, or razor knife.
3. Assemble the flush mount cup, clamp, and machine xxxx loosely.
4. Route the wires through the round opening in the bottom of the cup.
5. Press the assembly into the hole until the clamp edge is below the mounting surface, then tighten the xxxx .
6. Connect the wires from the tweeter terminals of the crossover to the tweeter using faston connectors.
7. Mount the tweeter by snapping it into the mounting cup.
For surface mount installation, follow these steps:
1. Use the base of the surface mount cup as a template and mark the xxxx hole locations.
2. Drill the xxxx holes using a 1/8" drill bit.
3. Drill a second hole for the speaker wire using a 3/16" drill bit.
4. xxxx the surface mount cup to the panel.
5. Push the tweeter wires through the bottom of the cup and through the hole in the panel.
6. Connect the wires from the tweeter terminals of the crossover to the tweeter wires using faston connectors.
7. Mount the tweeter by snapping it into the mounting cup.
Please refer to the provided operational guide for detailed diagrams and instructions on the Polk Audio MM652 marine speakers installation process.
Add New Comment