User Manual Q&AAnswer
Dec 31, 2024 - 04:32 AM
To connect the Dual Audio LU47PW speakers to your computer, you will need to use speaker wire and connect it to the speaker inputs on the back of the speakers. Here are the steps to connect the speakers:
1. Measure enough speaker wire to reach from your computer to each speaker, allowing for some extra length for flexibility.
2. Strip the insulation from the ends of the speaker wire to expose the bare wire.
3. Identify the positive (+) and negative (-) terminals on the back of the speakers. The positive terminal is usually marked with a "+" symbol or a red color, while the negative terminal is marked with a "-" symbol or a black color.
4. Insert the stripped end of the positive speaker wire into the positive terminal on one speaker, and tighten the terminal to secure the wire. Repeat this step for the negative speaker wire, inserting it into the negative terminal on the same speaker.
5. Repeat steps 3 and 4 to connect the other speaker to the computer using the remaining speaker wire.
6. Once both speakers are connected, you can position them in your desired location, whether it's indoors or outdoors.
7. Make sure to connect the other end of the speaker wire to the appropriate audio output on your computer. This could be the headphone jack, line-out jack, or a dedicated speaker output.
8. Adjust the volume on your computer and the speakers to your desired level.
Please refer to the operation manual for any additional information or troubleshooting tips.
Add New Comment