User Manual Q&AAnswer
Dec 30, 2024 - 03:54 AM
To install the MartinLogan Motion 8i Center Channel Speaker on a wall, follow these steps:
1. Determine the mounting location using a level and the provided installation template.
2. Mark the pilot hole locations on the wall.
3. Drill the pilot holes using a 1/8-inch drill bit. If a pilot hole does not hit a stud, widen that pilot hole using a 1/4-inch drill bit and install a wall anchor at that location.
4. Using the provided 1-inch Phillips screws, mount the wall bracket(s) as shown in the instructions.
5. xxxx the shoulder bolt(s) into the back of the speaker. For horizontal installation, use two shoulder bolts. For vertical installation, use one shoulder bolt.
6. Affix the wall pads to the back of the speaker at the lower contact points.
7. Hang the speaker on the wall brackets, guiding the wall mount bolt into the wall bracket keyhole(s).
Please note that these instructions assume the mounting surface is standard wood frame and sheet rock construction. If you wish to mount the speaker on another type of surface, it is recommended to consult a bonded contractor.
For more detailed instructions and illustrations, refer to the "Installation" section of the MartinLogan Motion 8i Center Channel Speaker Instruction Manual.
Add New Comment