User Manual Q&AAnswer
Dec 30, 2024 - 02:43 AM
To install the Amplivox Indoor/Outdoor 100W Power Horn Speaker, follow these steps:
1. Adjustment: The speaker is equipped with a pivoting, cast iron base. Loosen the wing nut connecting the base to the horn and remove the base. If you wish to rotate the horn between vertical and horizontal positions, use a screwdriver to loosen the xxxx on the back of the speaker. Tighten the xxxx securely when the desired position is reached.
2. Base: The base has 3 holes for screws (not included). Use screws with a diameter greater than 1/4" to ensure safe installation. xxxx the base to the mounting surface where you want to install the horn. Reattach the horn to the base, rotate it to your desired angle, and tighten the wing nut securely.
3. Wiring: The wire connections are sealed internally for weatherproofing. Access the wires through a 20" lead. Connect the Brown wire (positive) and Black wire (negative/ground) to the corresponding 8-ohm outputs on your amplifier.
If you want to use the tamper loop functionality, connect the Red and Green wires to the appropriate circuit in your alarm system. This allows an alarm to be triggered if the circuit is broken. Note that this is normally a closed (NC) circuit.
For more detailed information and illustrations, please refer to the Amplivox Indoor/Outdoor 100W Power Horn Speaker User Guide provided above.
Add New Comment