User Manual Q&AAnswer
Dec 29, 2024 - 11:30 PM
To connect a powered subwoofer and four speakers to the Lanzar EV594 amplifier, you can use the line out RCA jacks for the powered subwoofer and the speaker terminals for the speakers. Here's how you can do it:
1. Connect the RCA cables from the line out RCA jacks on the amplifier to the input of the powered subwoofer. Make sure to use high-quality shielded RCA cables for optimal signal quality.
2. Connect the speakers to the speaker terminals on the amplifier. The EV594 amplifier supports 2-ohm stable stereo operation, so you can connect two speakers to each pair of channels. Use high-quality speaker wire and ensure proper polarity (+/-) when connecting the speakers.
3. Set the crossover mode selector on the amplifier to the appropriate mode for your setup. If you want to send low-frequency signals to the subwoofer and high-frequency signals to the speakers, select the low pass mode for the subwoofer and the high pass mode for the speakers. If you want to send the full range of frequencies to both the subwoofer and speakers, select the flat mode.
4. Adjust the variable low pass filter and variable high pass filter controls on the amplifier to set the desired frequency range for the subwoofer and speakers, respectively. Refer to the manual for the recommended frequency ranges.
5. Power up the amplifier and the subwoofer. Make sure to follow the installation instructions in the manual for proper power and ground connections.
By following these steps and referring to the manual for specific details and settings, you can successfully connect a powered subwoofer and four speakers to the Lanzar EV594 amplifier for a complete audio system in your car.
Add New Comment