User Manual Q&AAnswer
Dec 29, 2024 - 11:16 PM
To connect a powered subwoofer and four speakers to the Lanzar EV484 car power amplifier, you can use the line out RCA jacks and the high-level inputs. Here's how:
1. Connect the line out RCA jacks on the amplifier to the input of your powered subwoofer using high-quality RCA cables. This will allow you to send the audio signal from the amplifier to the subwoofer.
2. Connect the high-level inputs on the amplifier to the speaker outputs of your head unit using speaker wire. This will allow you to connect four speakers to the amplifier.
3. Make sure to set the amplifier's crossover mode selector to the appropriate setting for your setup. If you want to send low-frequency signals to the subwoofer, set it to low pass mode. If you want to send high-frequency signals to the speakers, set it to high pass mode. If you want to send the full range of frequencies to both the subwoofer and speakers, set it to flat mode.
4. Adjust the level controls on the amplifier to match the output levels from your head unit or other signal source. This will ensure that the audio signal is properly matched between the source and the amplifier.
5. Fine-tune the various controls on the amplifier, such as the variable low pass filter and variable high pass filter, to achieve the desired sound quality and frequency response.
By following these steps, you can successfully connect a powered subwoofer and four speakers to the Lanzar EV484 car power amplifier. For more detailed instructions and information, please refer to the owner's manual provided with the amplifier.
Add New Comment