User Manual Q&AAnswer
Dec 29, 2024 - 11:01 PM
To connect the Polk ES10 Signature Elite Surround Loudspeakers to your system, follow these steps:
1. Wire Preparation: Strip 1/2" (12.7mm) of insulation from each of the two conductors of the wire to expose the bare metal. Twist each of the individual conductors into single unfrayed strands.
2. Speaker Wire Connection: Connect the wire from the positive (+) terminal of your amplifier or receiver to the red (+) terminal on your speaker. Connect the wire from the negative (-) terminal of your amplifier or receiver to the black (-) terminal on your speaker. Make sure to maintain consistency with the wire connections.
3. Binding Posts: To connect the wire to the binding post, unscrew the binding post cap and insert the bare wire into the hole near the base of the binding post. Do not insert the insulated part of the wire into the hole. Tighten the binding post cap until it seats firmly with the wire, but do not over tighten.
4. Optional Connectors: You have several options when choosing connectors for your speaker wires, such as banana plugs, spade lugs, or bare wire. Choose the connector type that suits your preference. Banana plugs can be used with the Signature Series binding posts by prying out the binding post plugs to expose the banana plug holes.
5. Repeat for Multiple Speakers: If you have multiple Polk ES10 Signature Elite Surround Loudspeakers, repeat the above steps for each speaker, ensuring proper wire connections and binding post attachment.
6. Amplifier Settings: Set your amplifier or receiver to the appropriate settings for your speaker setup. Refer to your amplifier's user manual for instructions on configuring the settings for your specific setup.
By following these steps, you should be able to properly wire and connect your Polk ES10 Signature Elite Surround Loudspeakers to your audio system. For more detailed information and illustrations, please refer to the user manual provided with the speakers.
Add New Comment