User Manual Q&AAnswer
Dec 29, 2024 - 08:48 AM
To connect the Nuvo NVP500NA System Soundbar Wireless Sub to your TV, please follow these steps:
1. Determine if the Sound Bar will be free-standing or mounted to the wall.
2. Perform the Sound Bar installation:
- Free-standing Sound Bar installation: Attach the two rubber feet to the bottom of the Sound Bar.
- Wall-mount Sound Bar installation: Hold the bracket up to the wall at the mounting location, making sure the bracket is level and located in an area where it can be attached to the wall studs. Use the bracket as a template to mark the four placement holes for the bracket fasteners. Use the four fasteners (provided) to secure the bracket to the wall.
3. Plug the provided 2 m Ethernet cable into the Ethernet port on the back of the Sound Bar. An Ethernet cable MUST be used for the initial setup of the P500.
4. Determine if you are using RCA cables or the TOSLINK cable for your audio:
- RCA Cables: Plug the RCA cables into the RCA jacks (Analog Input). The red RCA cable plugs into the red jack on the back of the Sound Bar. The white RCA cable plugs into the white jack on the back of the Sound Bar.
- TOSLINK cable: Plug one end of the TOSLINK cable into the optical input port on the back of the Sound Bar.
5. If a micro-USB drive is being used with the Sound Bar, insert it at this time.
6. Plug the Sound Bar power cable with the 90° angled head into the Sound Bar power cord inlet on the back of the Sound Bar.
7. Plug the Subwoofer power cable into the Subwoofer power cord inlet on the back of the Subwoofer.
8. Pair the Sound Bar to the Subwoofer using one of the following methods, as appropriate:
- Method 1: Pairing a Sound Bar with a new Subwoofer: Press the sync button on the Subwoofer until the LED flashes blue, approximately five (5) seconds. Press the sync button on the Sound Bar until the red LED turns off on the Sound Bar. When the Subwoofer LED changes to a solid green color, the pairing is complete.
- Method 2: Pairing a Subwoofer that has previously been paired to a Sound Bar [reset required]: Reset the Sound Bar to the factory default state. Press and hold the sync button on the Subwoofer until the LED flashes blue, approximately five (5) seconds. Plug in and set up the Sound Bar. Press and hold the sync button on the Sound Bar for approximately five (5) seconds. The Subwoofer Sync LED stops flashing blue when the pairing is complete.
9. If mounting the Sound Bar to the wall, slide the Sound Bar over the top of the mounting bracket until the tabs on the back of the Sound Bar lock into place over the top lip of the mounting bracket. Make sure all of the cables exit the sides and are not pinched between the Sound Bar and the mounting bracket. Secure the Sound Bar to the mounting bracket using the safety latch.
10. Connect the Sound Bar cables to the television (TV): Ethernet cable to the Ethernet port on the TV, Red RCA cable to the corresponding audio output jack on the TV, White RCA cable to the corresponding audio output jack on the TV, TOSLINK Cable to the optical output port on the TV.
11. Plug the Sound Bar and Subwoofer into the appropriate power outlets and power on the devices.
12. Download and launch the Nuvo Player Portfolio App from the Apple App Store or the Google Play store. Follow the on-screen instructions in the App to complete the P500 setup.
Please refer to the Nuvo NVP500NA System Soundbar Wireless Sub User Manual for more detailed information and troubleshooting tips.
Add New Comment