User Manual Q&AAnswer
Dec 29, 2024 - 05:24 AM
Sure! Here are the step-by-step instructions for setting up the KING VQ4510 Tailgater Bundle Portable Satellite:
1. Find a location with an unobstructed view of the southern sky. Make sure there are no trees, buildings, or other obstructions that could block the satellite signal.
2. Apply the rubber feet to the antenna unit if they haven't been installed already. Lay the unit on a soft, non-scratching surface and remove the rubber feet from the bottom of the unit.
3. Connect one end of the supplied RG-6 coax cable to the MAIN port on the KING Tailgater and place it in position. It is recommended to use only the supplied RG-6 coax cable.
4. Connect the other end of the coax cable to the SATELLITE IN port on your receiver.
5. Plug your receiver into a 110-volt AC power source. The green power light on your receiver should illuminate or begin cycling on and off. Wait for the green light to turn solid. This may take up to two minutes. If it does not turn solid, power on your receiver using the front panel POWER button.
6. Plug in and turn on your TV. In your TV's input selection menu, choose the input that matches the connection from your receiver. For example, if using an HDMI cable from your receiver, choose the HDMI input on your TV.
7. Point your receiver's remote at the front of the receiver and press SAT.
8. Press RECORD.
9. When a number appears in the box, verify that CONTINUE is highlighted.
10. Press SELECT on your remote.
11. The Portable Antenna Setup screen will display. Use the arrow buttons on your remote to highlight the letter group that includes the first letter of the state you are currently in.
12. Press SELECT.
13. Highlight the state you are currently in from the state menu.
14. Press SELECT.
15. Verify that Scan is highlighted.
16. Press SELECT.
17. The scan will begin and may take up to several minutes to complete.
18. The receiver will download software for the KING Tailgater. This step may take 20-25 minutes.
19. The receiver will reset, and the Mobile Antenna Setup Screen will appear.
20. Repeat steps 2-4 to start a second scan.
21. When the scan is complete, the Acquiring Signal message will display. Acquiring the signal may take up to 5 minutes to complete.
22. After your receiver has acquired the signal, it is ready to be activated. To activate service, call 1-800-963-DISH (3474).
23. After your receiver is activated, the electronic program guide will download. This may take up to 10 minutes to complete.
That's it! Your KING VQ4510 Tailgater Bundle Portable Satellite should now be set up and ready to use. If you have any further questions or issues, refer to the user manual or contact the KING Service Department for assistance.
Add New Comment