User Manual Q&AAnswer
Dec 28, 2024 - 11:57 PM
Calibrating the BOAK Test Light Automotive is a straightforward process. Here's how you can do it:
1. Ensure that the tester is turned off and disconnected from any power source.
2. Locate the calibration xxxx on the tester. It is usually located near the probe or on the side of the device.
3. Use a small screwdriver to adjust the calibration xxxx . Turning it clockwise will increase the voltage reading, while turning it counterclockwise will decrease the reading.
4. To calibrate the tester, you will need a known voltage source. Connect the tester to the known voltage source.
5. Turn on the tester and compare the displayed voltage reading with the known voltage. If there is a difference, adjust the calibration xxxx accordingly until the displayed voltage matches the known voltage.
6. Once the calibration is complete, disconnect the tester from the known voltage source and turn it off.
7. Test the tester on different circuits to ensure that it is providing accurate readings.
Note: It is recommended to refer to the user manual for specific calibration instructions and any additional information provided by the manufacturer.
Add New Comment