User Manual Q&AAnswer
Dec 28, 2024 - 09:39 PM
To connect your speakers to the AudioSource Analog Amplifier, follow these steps:
1. Determine whether you will be using the amplifier in stereo mode or bridged mode. In stereo mode, each speaker will have its own channel, while in bridged mode, the amplifier will output a mono signal to a single speaker.
2. For stereo mode: Connect the positive (red) terminal of each speaker to the corresponding positive (red) terminal on the amplifier. Connect the negative (black) terminal of each speaker to the corresponding negative (black) terminal on the amplifier. Make sure to observe proper polarity.
3. For bridged mode: Place the "MODE" switch on the amplifier in the "BRIDGED" position. Connect the positive (red) terminal of your speaker to the red (+) terminal noted next to the bridging mark on the amplifier. Connect the negative (black) terminal of your speaker to the unmarked positive (red) terminal on the amplifier.
4. Ensure that the impedance of your speakers is compatible with the amplifier. In stereo mode, the minimum impedance is 4 ohms, and in bridged mode, the minimum impedance is 8 ohms.
5. Repeat the above steps for each speaker you wish to connect.
Please refer to the user manual for additional information and diagrams on speaker connections.
Add New Comment