User Manual Q&AAnswer
Dec 28, 2024 - 09:03 PM
To connect the Pyle-Pro PAHT4 4 Way DJ Tweeter System to your amplifier, follow these steps:
1. Make sure the amplifier is turned off and the volume level is set to zero.
2. Locate the "Quick Connect" speaker terminals on the back of the PAHT4 speaker cabinet.
3. Use at least 14 gauge unshielded speaker cable to connect the amplifier to the PAHT4 speaker. Strip the ends of the speaker cable to expose the bare wire.
4. Insert the bare wire into the corresponding positive (+) and negative (-) terminals on the speaker cabinet. Make sure the positive wire is connected to the positive terminal and the negative wire is connected to the negative terminal.
5. Tighten the terminals to secure the speaker cable in place. Ensure a tight connection to prevent any signal loss or interference.
6. Repeat the process for the other channel if you are using a stereo setup.
7. Once the connections are secure, turn on the amplifier and gradually increase the volume to your desired level.
Please refer to the user manual for any additional information or troubleshooting tips regarding the connection of the PAHT4 speaker system to your amplifier.
Add New Comment