User Manual Q&AAnswer
Dec 28, 2024 - 07:02 AM
To adjust the chain tension on the WORX WG320 Trimming Chain Saw, follow these steps:
1. Make sure the tool is switched off and the battery is removed.
2. Push the rear handle until the guide bar is in the middle of the jaw opening and lock the guide bar in place by inserting the lock pin into the lock pin receptacle.
3. Open the chain access cover by using the supplied wrench.
4. Release tension on the saw chain by loosening the chain tensioning bolt counterclockwise.
5. Add tension to the saw chain by turning the chain tensioning bolt clockwise. The automatic chain tensioning system will set the tension to the saw chain.
6. Check that the correct saw chain tension has been set. It should be possible to pull the saw chain away from the side of the guide bar approximately 3mm and it should snap back.
7. If the tension is incorrect, repeat step 4, ensuring the guide bar is free to move when the tension is released.
8. Close the chain access cover and remove the lock pin.
For more detailed instructions and illustrations, please refer to the WORX WG320 Trimming Chain Saw User Manual.
Add New Comment