User Manual Q&AAnswer
Dec 28, 2024 - 06:49 AM
To change the LED light mode on the , follow these steps:
1. Turn on the lightbox by pressing the power button located on the side or bottom of the lightbox.
2. Once the lightbox is turned on, you will see the default LED light mode, which is usually the white mode.
3. To switch to a different LED light mode, press the mode button located next to the power button. Each press of the mode button will cycle through the available light modes.
4. The My Cinema Lightbox FBA-MULTI offers three LED light modes: white mode, color-change mode, and freeze mode.
- White Mode: This mode features a bright white LED light that provides the best range without dimming or spotting.
- Color-Change Mode: In this mode, the RGB LEDs slowly move through the color spectrum, creating a color-changing effect.
- Freeze Mode: This mode allows you to select and hold on to any color of your choice. Press the mode button when you reach the desired color to freeze it.
5. Keep pressing the mode button until you find the LED light mode you prefer.
Note: If the lightbox is not responding to the mode button or the LED light modes are not working properly, there may be a fault with the LED control. In such cases, it is recommended to check the power source or reset the light modes according to the troubleshooting section of the user manual.
Add New Comment