User Manual Q&AAnswer
Dec 28, 2024 - 05:05 AM
To switch between self-leveling mode and manual mode on the ENVENTOR EN011R Red Self-Leveling Laser Level, please follow these steps:
1. Power on the laser level by pressing the power button.
2. The device will automatically enter self-leveling mode, where it will level itself within ±4 degrees.
3. To switch to manual mode, locate the toggle button on the laser level.
4. Press the toggle button once to switch to manual mode.
5. In manual mode, the laser level can project lines at any angle.
6. To switch back to self-leveling mode, press the toggle button again.
7. The laser level will return to self-leveling mode and level itself within ±4 degrees.
Please note that when in manual mode, the laser lines will flash every 5 seconds to provide visual confirmation of the mode.
If you are still experiencing difficulties switching between modes, please refer to the user manual for further instructions or contact ENVENTOR customer support for assistance.
Add New Comment