User Manual Q&AAnswer
Dec 28, 2024 - 04:55 AM
To change the lighting modes on the Qianwei 3D Crystal Butterfly Gift, follow these steps:
1. Ensure that the LED base is properly connected to a power source. You can use three AAA batteries or a USB cable to power the base.
2. Once the LED base is powered on, locate the touch switch on the base. It is usually located on the side or bottom of the base.
3. To cycle through the lighting modes, lightly touch the touch switch. Each touch will change the mode.
4. The Qianwei 3D Crystal Butterfly Gift offers six lighting modes: slow flashing multi-colored, fast flashing multi-colored, constant white light, red light, blue light, and green light. Keep touching the switch until you reach the desired lighting mode.
5. To turn off the LED base, touch and hold the touch switch for a few seconds until the light goes off.
Note: If the lighting modes are not changing when you touch the switch, make sure your touch is clean and firm. Sometimes, dirt or debris on the switch can affect its responsiveness. Additionally, if the LED base is not lighting up at all, check the battery installation or the USB connection to ensure a proper power source.
For more information and troubleshooting tips, please refer to the user manual included in the package.
Add New Comment