User Manual Q&AAnswer
Dec 28, 2024 - 04:03 AM
To switch between self-leveling and manual modes on the Motovera LL Self Leveling Laser Level, please follow these steps:
1. Power on the device by pressing the power button located on the control panel.
2. Once the device is powered on, it will automatically enter the self-leveling mode. The laser lines will adjust within a 4-degree range to ensure precise alignments.
3. To switch to manual mode, press and hold the mode button for a few seconds until the indicator light changes or the laser lines stop moving.
4. In manual mode, you can manually adjust the laser lines to your desired position using the fine-tuning xxxx located on the device. Rotate the xxxx clockwise or counterclockwise to move the laser lines up or down.
5. To switch back to self-leveling mode, press and hold the mode button again until the indicator light changes or the laser lines start moving.
6. Repeat these steps whenever you need to switch between self-leveling and manual modes for different leveling tasks.
Please note that it is important to read the user manual thoroughly for a complete understanding of the device's operation and safety instructions. If you encounter any difficulties or have further questions, it is recommended to contact Motovera's customer service through their official website or via email at support@motovera.com for assistance.
Source: To switch between self-leveling and manual modes on the Motovera LL Self Leveling Laser Level, please follow these steps: 1. Power on the device by pressing the power button located on the control panel. 2. Once the device is powered on, it will automatically enter the self-leveling mode. The laser
Add New Comment