User Manual Q&AAnswer
Dec 28, 2024 - 03:44 AM
To replace the battery in the TEKCOPLUS AUTK-1036 Automotive Circuit Tester, follow these steps:
1. For the Sender:
a. Remove the xxxx on the back case of the Sender.
b. Take off the back case to access the battery compartment.
c. Replace the exhausted battery with a new 9V (6F22) battery.
d. Rejoin the back case and secure it with the xxxx .
2. For the Receiver:
a. Remove the xxxx on the battery compartment of the Receiver.
b. Open the battery cover to reveal the battery compartment.
c. Replace the exhausted battery with a new 9V (6F22) battery.
d. Close the battery cover and secure it with the xxxx .
Ensure that the batteries are inserted correctly, following the polarity markings inside the battery compartments. It is recommended to use alkaline batteries for optimal performance.
Please refer to the TEKCOPLUS AUTK-1036 Automotive Circuit Tester Instruction Manual for visual illustrations and additional information on battery replacement.
Add New Comment