User Manual Q&AAnswer
Dec 28, 2024 - 03:42 AM
To test for continuity using the ANCEL PB100 Vehicle Circuit Probe, follow these steps:
1. Set the tool to Resistance mode by pressing the Mode Button until the Resistance mode is selected on the LCD display.
2. Connect the auxiliary ground lead to a known good ground or the chassis of the vehicle.
3. Touch the probe tip to the wire or component you want to test for continuity. Make sure the probe tip makes good contact with the metal part of the wire or component.
4. If the wire or component has continuity, the LCD display will show a resistance value close to zero and the green LED will light up. You will also hear a beep tone.
5. If there is no continuity, the LCD display will show a resistance value other than zero and the green LED will not light up. There will be no beep tone.
Note: If the resistance value is greater than 100KΩ, the LCD will show "0L", indicating an open circuit.
By following these steps, you can easily test for continuity in wires and components using the ANCEL PB100 Vehicle Circuit Probe.
Add New Comment