User Manual Q&AAnswer
Dec 28, 2024 - 03:30 AM
To pair your JVC Gumy earbuds with your Bluetooth device, please follow these steps:
1. Make sure the Bluetooth device is within 1 meter of the earbuds when pairing.
2. Turn on the Bluetooth function on your device.
3. Remove any existing pairing information for the earbuds from your device's Bluetooth device list.
4. Put the earbuds in pairing mode by pressing and holding the buttons on both the left (L) and right (R) earbuds for approximately 3 seconds. The L indicator will start flashing rapidly and alternately between red and white, or you may hear a voice message saying "Pairing mode."
5. On your Bluetooth device, search for available devices and select "JVC HA-A10T" from the list.
6. Once the earbuds are successfully paired, the L indicator will stop flashing and remain lit in white.
If the earbuds are still not connecting, try the following troubleshooting steps:
1. Turn off the Bluetooth function on your device and then turn it back on.
2. Reset the earbuds by pressing and holding the button on the L earbud for approximately 15 seconds. The indicator will flash once after 10 seconds, and then continue pressing for another 5 seconds until the indicator flashes again. Release your finger after the second flash.
3. Repeat the pairing process from step 4.
If you are still experiencing issues with pairing, please refer to the user manual or contact JVC customer support for further assistance.
Add New Comment