User Manual Q&AAnswer
Dec 28, 2024 - 02:28 AM
To connect the A90 Elevation Speaker Module to your BP9000 loudspeakers, follow these steps:
1. Gently push down on the back of the magnetically-sealed aluminum top panel of your BP9000 speaker to remove it.
2. Align and place the A90 elevation speaker module within the top of your BP9000 speaker.
3. Press down evenly to ensure a tight seal. The connector port on the inside of the speaker perfectly mates with the connector plug on the underside of the A90 module.
4. Run speaker wire from any compatible Atmos or DTS:X receiver binding posts (often titled HEIGHT) to the top set of binding posts (titled: HEIGHT) on the bottom, rear side of your BP9000 speakers. Be sure to match + to +, and – to -.
Note: The A90 elevation speaker module requires a Dolby Atmos/DTS:X-enabled receiver and is maximized by Dolby Atmos/DTS:X-encoded source material.
For more detailed instructions and illustrations, please refer to the manual provided with the product.
Add New Comment