User Manual Q&AAnswer
Dec 27, 2024 - 10:33 PM
To install the KING MB8200 Antenna Mounting Plate, follow these steps:
1. Start by removing the old antenna from your RV roof, if applicable.
2. Clean the area where the mounting plate will be installed to ensure a secure attachment.
3. Place the KING MB8200 Antenna Mounting Plate over the existing xxxx holes left by the previous antenna. Make sure the hole pattern is 11 square inches or smaller.
4. Use the provided hardware to attach the mounting plate to the base of the KING Jack or KING OmniPro antenna. Ensure a tight and secure fit.
5. Once the mounting plate is securely attached, you can proceed with installing the KING Jack or KING OmniPro antenna onto the mounting plate.
6. Follow the specific installation instructions provided with the KING Jack or KING OmniPro antenna to complete the installation process.
For more detailed instructions and illustrations, please refer to the product manual provided with the KING MB8200 Antenna Mounting Plate.
Add New Comment