User Manual Q&AAnswer
Dec 27, 2024 - 09:01 AM
To install the Nilight 10014W LED Light Bar Wiring Harness Kit, follow these steps:
1. Connect the light bar wires to the wiring harness terminals, matching the black wire to black and red wire to red.
2. Run the rocker switch wires through the switch cutout/opening in the dash. Connect the 5-pin rocker switch with the wiring harness. Refer to the instructions in the manual for two different methods of connection.
3. Connect the wiring harness to the car battery. Attach the red wire (+) with the fuse to the positive terminal and the black wire (-) to the negative terminal.
4. Turn on the power and press the switch on/off to test the light.
Please note that it is important to strictly follow the instructions to avoid any hazards. If you are not comfortable with the installation, it is recommended to have a professional install it or install it under their guidance for optimal performance and safety.
Add New Comment