User Manual Q&AAnswer
Dec 27, 2024 - 02:54 AM
To terminate and trim all four pairs of the Legrand Keystone Jack using the Legrand Punch & Go tool, follow these steps:
1. Start by preparing the cable. Strip off the outer jacket of the cable to expose the individual wires. Make sure to leave enough length for termination.
2. Separate the pairs of wires and untwist them. Straighten each wire to ensure a clean termination.
3. Insert the wires into the appropriate color-coded slots on the Keystone Jack. Refer to the T568A or T568B wiring scheme, depending on your network configuration.
4. Once the wires are inserted, use the Legrand Punch & Go tool to terminate and trim them. Place the tool over the Keystone Jack and press down firmly until you hear a click. This will terminate all four pairs of wires in a single press.
5. After termination, use the tool to trim any excess wire that may be sticking out of the Keystone Jack. This will ensure a neat and professional installation.
6. Repeat the process for any additional Keystone Jacks you need to terminate.
By using the Legrand Punch & Go tool, you can save time and effort in terminating and trimming the wires of the Legrand Keystone Jack. Make sure to follow the proper wiring scheme and use the tool correctly for optimal results.
Add New Comment