User Manual Q&AAnswer
Dec 26, 2024 - 10:41 AM
To replace the batteries in the S-Union Maple Tree LED Table Lights, please follow these steps:
1. Locate the battery compartment: The battery compartment is usually located on the bottom or side of the table light. It may have a small latch or xxxx to secure it.
2. Open the battery compartment: If there is a latch, slide or push it to open the compartment. If there is a xxxx , use a screwdriver to loosen and remove it.
3. Insert the new batteries: Take three AA batteries (not included) and insert them into the battery compartment. Make sure to align the positive (+) and negative (-) ends of the batteries correctly with the markings inside the compartment.
4. Close the battery compartment: If there is a latch, close it by sliding or pushing it back into place. If there was a xxxx , tighten it securely.
5. Test the lights: Turn on the table lights to check if the new batteries are working properly. If the lights do not turn on, double-check the battery placement and ensure the batteries are fully charged.
Note: It is recommended to use fresh, high-quality batteries for optimal performance and longer battery life. Regularly check the battery life and replace the batteries as needed to maintain the brightness and functionality of the lights.
Add New Comment