User Manual Q&AAnswer
Dec 26, 2024 - 10:03 AM
To set up the BlissLights 900-00048_A Ark Laser Projector, follow these steps:
1. Carefully unpack the projector and check that all parts are present and in good condition.
2. Connect the USB power cord to a powered USB port or use the included wall adapter to connect to an electrical outlet.
3. Place the Ark on a flat, solid surface and aim it towards the desired ceiling or wall.
4. Press the power button to turn on the projector. The nebula and laser effects will gradually illuminate and begin moving by default.
5. If you want to adjust the illumination angle for walls, slide the unit down to the forward position.
6. To turn off the light, cycle through the power button modes until the unit turns off completely. Then, remove the power plug from the electrical outlet.
7. Use the buttons on the remote control to control the lighting effects. Button 1 controls the effects (power on, pulse mode, laser only, cloud only, power off). Button 2 controls rotation (rotation off, rotation on). Button 3 controls brightness (high, medium, low).
Please refer to the user's guide for more detailed information and illustrations on setting up and operating the BlissLights 900-00048_A Ark Laser Projector.
Add New Comment