User Manual Q&AAnswer
Dec 26, 2024 - 08:40 AM
To set the DMX address on the U`King ZQ02001 Moving Head DJ Light, follow these steps:
1. Make sure the unit is powered off and disconnected from any power source.
2. Locate the DMX address setting on the front panel of the fixture.
3. Use the UP and DOWN buttons to select the desired DMX address.
4. Press the ENTER button to confirm the DMX address selection.
5. Connect the unit to your DMX controller using a standard 3-pin XLR DMX cable.
6. Make sure the DMX controller is set to the same DMX address as the fixture.
7. Power on the fixture and the DMX controller.
Now, the U`King ZQ02001 Moving Head DJ Light should respond to the DMX control signals from your DMX controller. Make sure to refer to the DMX Modes & Values section of the user manual for information on the different DMX channels and their corresponding functions.
Add New Comment