User Manual Q&AAnswer
Dec 26, 2024 - 08:18 AM
To change the lighting modes on the DenicMic Firework01 Battery Operated Firework Lights, you can use the included remote control. Here are the steps to follow:
1. Ensure that the lights are powered on and the remote control is within the effective reception range of 40-50 feet.
2. Press the "Mode" button on the remote control. Each press of the button will cycle through the available lighting modes.
3. The lights have eight lighting modes: Combination, In Wave, Sequential, Slo Glo, Chasing/Flash, Slow Fade, Twinkle/Flash, and Steady On. Keep pressing the "Mode" button until you reach the desired lighting mode.
4. Once you have selected a mode, the lights will automatically adjust to that mode and continue to operate in that mode until you change it again.
Note: If the lights are not responding to the remote control, make sure there are no obstructions between the remote and the lights, and check that the remote batteries are functioning properly. Also, ensure that the remote control is within the specified reception range.
For more detailed instructions and troubleshooting tips, please refer to the "Setup Guide" section of the user manual provided with the product.
Add New Comment