User Manual Q&AAnswer
Dec 26, 2024 - 04:53 AM
To install the AUTOONE HB3 9005 LED Fog Light, please follow these step-by-step instructions:
1. Unbox and Check: Before starting the installation, carefully take the fog lights out of the box and inspect them for any damage or flaws.
2. Turn Off the Car: Ensure that your car is turned off before beginning the installation to avoid any power-related issues.
3. Find the Fog Light Housing: Locate the fog light housing on your vehicle. It is typically located on the front plate or in a position where you want to install the fog lights.
4. Take Out the Old Fog Lights: Unscrew and remove the old fog light bulbs from their sockets. Take caution not to damage the existing wiring.
5. Align the New 9005 LED Bulbs: Insert the AUTOONE 9005 LED bulbs into the fog light socket, ensuring they are properly aligned with the position where the old halogen bulbs were.
6. Plug in the Connectors: Connect the bulb's socket to the wiring plug on your car. Make sure the connection is secure and properly seated.
7. Test the Lights: Start your car and verify if the new LED fog lights are functioning correctly. Ensure they turn on and off as expected.
8. Adjust the Beam Angle: If necessary, adjust the beam angle to achieve the best light projection and ensure optimal visibility and safety.
9. Secure the Bulb: Once you are satisfied with the placement and alignment of the fog light bulbs, use the appropriate screws to secure them in place.
10. Repeat on Both Sides: If you are installing fog lights on both sides of your vehicle, repeat the above steps for the other side.
11. Check for Error Codes: If your car displays error codes after installation, you may need to install an additional decoder to address compatibility issues.
12. Reconnect the Battery: Ensure that the car's battery is properly reconnected to avoid any electrical problems.
13. Test the Fog Lights Again: After completing the entire installation process, verify that both fog lights are still functioning correctly.
14. Ensure Waterproofing: Make sure the fog light housing is properly sealed to prevent water and dust from entering.
15. Test in Different Weather Conditions: Finally, test the fog lights in various weather conditions to ensure they function as intended.
Please note that these instructions are a general guide, and it is always recommended to consult the specific instruction manual provided with the AUTOONE HB3 9005 LED Fog Light for any additional details or precautions specific to your vehicle model.
Add New Comment