User Manual Q&AAnswer
Dec 26, 2024 - 04:47 AM
Installing the Auxbeam NIGHTEYE-0196 LED Fog Light Bulb is a relatively straightforward process. Here are the step-by-step instructions to help you with the installation:
1. Check Vehicle Compatibility: Before starting the installation, check your car's user manual or the original fog light bulbs to ensure that your car uses 5202, 5201, H16, PS24W, or 9009 bulbs, which are compatible with the Auxbeam NIGHTEYE-0196.
2. Turn Off Your Car: Always make sure that your car is turned off and the engine is cool before starting any installation process.
3. Locate the Fog Light Housing: Open the front of your car and locate the fog light housing. If you're unsure of its location, refer to your car's instructions or consult a professional.
4. Remove Old Fog Light Bulbs: Carefully twist or unclip the old fog light bulbs from their base to remove them, if necessary.
5. Prepare the New LED Bulbs: Take the Auxbeam NIGHTEYE-0196 LED bulbs out of the box and inspect them for any damage.
6. Install the LED Bulbs: Plug the LED fog light bulb into the socket. The Auxbeam NIGHTEYE-0196 bulbs do not require specific polarity, so you don't need to worry about the connectors' orientation. Ensure that the bulb fits firmly in the housing.
7. Test the Bulb: Start your car and check the fog light bulb to ensure it is functioning correctly.
8. Position the Bulb Correctly: Make sure the bulb is properly aligned and positioned inside the housing to ensure the light beam is directed correctly.
9. Install the Bulb Cover: After inserting the bulb, cover or seal it with the fog light cover to protect it from dust and water.
10. Check for Error Codes: If your car has a CAN-BUS system, check for any error codes on the dashboard after installation. In some cases, you may need to add load resistors to prevent error codes or flashing problems.
11. Adjust the Fog Lights: Ensure that the fog lights are properly aligned to illuminate the road ahead without causing glare for other drivers.
12. Test in Low Visibility Conditions: To ensure proper functionality, test the fog lights at night or in foggy conditions to verify their effectiveness.
13. Double-Check Connections: Verify that all wires and connections are securely attached, and there are no exposed or loose wiring.
14. Secure the Fog Light Assembly: Tighten any screws or mounts to ensure that the fog light assembly is tightly fastened, holding the bulb securely in place.
15. Final Function Test: Perform a final test to ensure that the fog lights are working correctly and providing the desired amount of light.
Please note that these instructions are a general guide, and it's always recommended to consult the specific user manual provided with the product for detailed installation steps and any additional precautions or recommendations.
Add New Comment