User Manual Q&AAnswer
Dec 26, 2024 - 04:11 AM
To change the filament in the MYNT3D MP012-WH OLED Display Printing Pen, follow these steps:
1. Bring your 3D Pen up to temperature.
2. Press and hold the withdraw button until the filament is free.
3. Ensure the new filament is cut correctly and loaded into the pen.
The manual does not provide specific instructions on how to cut and load the new filament, but it is recommended to straighten the end of the filament if necessary and insert it into the filament loading hole until it stops. Press and hold, or double-click the feed button to load filament into the pen. Sliding the speed control all the way up will make this process faster.
Please note that it is advised to only use the withdraw button when changing filament. If the filament is only partially withdrawn, it can deform in the barrel and the pen will not extrude. If this happens, you should fully withdraw the filament and cut off the deformed section.
For more detailed instructions and illustrations, please refer to the MYNT3D MP012-WH OLED Display Printing Pen User Manual.
Add New Comment