User Manual Q&AAnswer
Dec 26, 2024 - 02:21 AM
To sync the remote control with the John Deere 42946A1 Radio Controlled Johnny Tractor, follow these steps:
1. Make sure both the tractor and the remote control are turned off.
2. Turn on the tractor by flipping the power switch located on the tractor.
3. Turn on the remote control by pressing the power button or switch on the remote.
4. Wait for a few seconds to allow the remote control and tractor to establish a connection.
5. Test the remote control by pressing the buttons to see if the tractor responds to the commands.
If the remote control and tractor are still not syncing, try the following troubleshooting steps:
1. Check the battery levels in both the remote control and the tractor. Replace the batteries if they are low or empty.
2. Ensure that there are no obstructions between the tractor and the remote control that may interfere with the signal.
3. Reset the remote control by turning it off and on again.
4. Move the tractor closer to the remote control to ensure it is within range.
5. Clean the buttons on the remote control to remove any dirt or debris that may be affecting their functionality.
If you have followed these steps and are still experiencing issues with syncing the remote control with the tractor, refer to the product manual or contact John Deere customer service for further assistance.
Add New Comment