User Manual Q&AAnswer
Dec 25, 2024 - 11:07 AM
To pair the remote control with the kolegend 1331 Remote Control Excavator Toy, please follow these steps:
1. Make sure both the toy and the remote control have fresh batteries installed.
2. Turn on the switch of the toy, located at the bottom of the rear.
3. Turn on the remote control by inserting two 1.5V AA batteries (not included) and flipping the switch to the ON position.
4. The toy and remote control will automatically pair and find the frequency. During this process, the remote control's LED light will blink.
5. Wait until the LED light on the remote control stops flashing. This indicates that the frequency matching is completed, and the remote control function can be used normally.
If you encounter any issues during the pairing process, such as the LED light on the remote control continuously flashing or the toy not responding, please ensure that both the toy and remote control have sufficient battery power. If the problem persists, try turning off both the toy and remote control, recharge or replace the batteries, and then repeat the pairing process.
For further assistance or troubleshooting, please refer to the kolegend 1331 Remote Control Excavator Toy User Manual or contact kolegend customer service at kolegend-US@outlook.com.
Add New Comment