User Manual Q&AAnswer
Dec 25, 2024 - 09:32 AM
To pair the HAWK'S WORK 822 Remote Control Airplane with the remote controller, follow these steps:
1. Install batteries: Make sure you have installed the batteries in both the airplane and the remote controller.
2. Turn on airplane power: Turn on the power of the airplane by flipping the switch or pressing the power button. The indicator on the airplane should start flashing, indicating that it is ready to pair with the remote.
3. Prepare the remote: Put the throttle (left joystick) on the remote controller at the lowest position and turn on the power of the remote controller.
4. Pairing process: Push the throttle (left joystick) on the remote controller to the top and then pull it down to the bottom slowly. During this process, pay attention to the indicators on both the airplane and the remote controller.
5. Successful pairing: After following step 4 correctly, both the indicator on the airplane and the indicator on the remote controller should stay constant on, indicating that the airplane is successfully paired with the remote controller.
Note: It is important to follow the above steps strictly and move the throttle (left joystick) slowly in step 4. If you fail in pairing, please turn off the powers of both the airplane and the remote controller and try again.
For more information and troubleshooting, please refer to the HAWK'S WORK 822 Remote Control Airplane User Manual.
Add New Comment