User Manual Q&AAnswer
Dec 25, 2024 - 05:07 AM
To change the light bulb in the VP Home G169 Wall Plug-in Wax Warmer, please follow these steps:
1. Ensure the power is off: Before attempting to change the light bulb, make sure the warmer is unplugged from the wall outlet and that the power is turned off.
2. Locate the light bulb: The light bulb is located inside the warmer, underneath the dish where the wax melts. It may be covered by a small protective cover or shield.
3. Remove the protective cover: If there is a cover or shield over the light bulb, gently remove it by twisting or pulling it off. Be careful not to apply too much force to avoid damaging the cover or the warmer.
4. Unscrew the old bulb: Once the protective cover is removed, you will see the light bulb. Carefully unscrew the old bulb from its socket by turning it counterclockwise. Take note of the bulb type and wattage for replacement.
5. Replace with a new bulb: Insert a new bulb of the same type and wattage into the socket. Make sure it is securely screwed in by turning it clockwise until it is snug.
6. Replace the protective cover: If you removed a protective cover or shield in step 3, place it back over the light bulb. Ensure it is properly aligned and securely attached.
7. Plug in and test: After replacing the light bulb, plug the warmer back into the wall outlet and turn on the power. Check if the new bulb is working properly and providing the desired illumination.
Note: Always ensure the power is off and the warmer is unplugged before attempting to change the light bulb. If you are unsure about the specific bulb type or wattage to use, refer to the user manual or contact VP Home customer support for assistance.
Add New Comment