User Manual Q&AAnswer
Dec 25, 2024 - 04:00 AM
To control the temperature on the SCRIB3D P1 3D Printing Pen, follow these steps:
1. Press the power button to turn on the pen and wait for it to heat up. The temperature indicator light will be red while heating up and will turn green when the pen is ready.
2. On the display, you will see "ABS" or "PLA" indicating the mode. Use the Temperature Up/Down buttons to select the mode that corresponds to the type of plastic filament you are using.
3. Once you have selected the mode, press the Forward Button to activate it. You can then use the Temperature Up/Down buttons to fine-tune the temperature depending on your needs and desired usage.
4. The temperature ranges for ABS filament are 200-230°C, and for PLA filament, they are 160-210°C. Adjust the temperature within these ranges based on the specific requirements of your filament.
5. The Temperature Indicator Light will indicate the heating status. It will be red while heating up and will turn green when the pen reaches the set temperature.
By following these steps, you can control the temperature of the SCRIB3D P1 3D Printing Pen and ensure that it is set correctly for the filament you are using. Remember to always use the appropriate temperature for the specific type of filament to achieve the best results.
Add New Comment